Turning The Beaglebone On A Chip Into A 3D Printer Controller

See the original posting on Hackaday

It’s understood that 3D printers and CNC machines need to control motors, but there are a few other niceties that are always good to have. It would be great if the controller board ran Linux, had support for a nice display, and had some sort of networking. The usual way of going about this is either driving a CNC machine from a desktop, or by adding a Raspberry Pi to a 3D printer.

The best solution to this problem is to just drive everything from a BeagleBone. This will give you Linux, and with a few motor drivers you can …read more